It is preferable to run the blower on at low RPM (about 400/500 RPM) (not completely switch off) when conventional sintering process is carried out. It is important to note that during initial start up of furnace or start up after a shut down, ensure that the blower is on during N2 purging before allowing the active gases such as DA, in order to remove entrapped air from the blower section.
鷺稽嬢研 碍精 硝杷織拭辞(刃穿備 什是帖 神覗亜 焼観) 錘慎馬澗 依戚 識硲鞠嬢遭陥. 析鋼旋昔 社衣引舛戚 遭楳吃 凶. 戚依精 置社稽 亜疑馬暗蟹 偲斗錘廃 板拭 亜疑拝 凶 掻推馬陥. 溌叔備 鷺稽嬢 佃虞, N2研 因奄壕奄馬澗 疑照 DA人 旭精 醗失亜什亜 爽脊鞠奄 穿拭 鷺稽嬢悉芝生稽採斗 阿微 因奄研 薦暗馬奄 是背